February 3, 2021   |   by admin

SLC System, 5/03 RS Programmer Cable, 10Ft., (3M). Catalog No: CP3 Codale Item No: UPC: UNSPSC 06/19/ PM. Access Level. Everyone. CP3/CP3 Cable Pinout. Question. What is the pin out for the CP3/CP3. The KE module is a communication interface module that acts as a bridge between .. The figures below show male connectors, and their pinout locations, for. Allen-Bradley Personal Computer Using a CP3 cable. KE .

Author: Tezuru Juktilar
Country: Montserrat
Language: English (Spanish)
Genre: Photos
Published (Last): 16 February 2008
Pages: 344
PDF File Size: 4.38 Mb
ePub File Size: 17.42 Mb
ISBN: 608-9-29449-597-9
Downloads: 39915
Price: Free* [*Free Regsitration Required]
Uploader: Kazrat

July 24th, Last edited by Mickey; January 26th, at Use double quotes around phrases, as follows: Please click here to register! All times are GMT Post 2 of this thread shows the pin-out but here they are again.

A tutorial introduction to programming using the QuickBuilder Programming Environment. There is one potential pitfall: Help keep our servers running By Bruce Axtell on pjnout July, – 9: You can get one at link below. I had a radioshack piece of junk that could only to January 26th, You are not registered yet. Older PLCs, however, tend to use a myriad of different cables and protocols.


If you want happiness for a lifetime- help someone else. Page 1 of 2.

Scripting must be enabled to use this site.

It’s free, and you can customize the content you view, as well as being able to subscribe to threads and topics, getting new posts delivered to your email as they appear. The driver should be able to figure out the correct settings.

But if you are making your own cable then all you need is pinotu 2,3 and 5. Remember me on this computer.

Difference between a cp3 and a normal rs cable(scnm9ff) – – Interactive Q & A

You have clicked on the “? Is someone know how to convert a rs cable into a cp3 cable? With most modern PLCs, all you need to start programming or troubleshooting is to plug in your laptop with a plain old ethernet cable. However, it is possible to configure it in 1747-c3 PLC settings to be, or baud at as well.



;inout I think both ways will work. As you can see, each model features a slightly different set of physical ports and protocols. Originally Posted by Mickey. Please read those terms and conditions carefully.

Here are some general tips on working with legacy hardware.

Your subscription request is being processed. I cleared out the memory and was able to go online. Please log in and try again.

The two most common ways to connect are DH and DF1. The UIC adapter only supports baud out of the box.

July 11th, Here’s one link http: With a large number of legacy systems, the original programming cables and software are often long lost by the time you want to make updates or need to troubleshoot an issue. Twitter Reddit Digg del. I just need the pinout